This is a house I bought a year ago. The kitchen light on the ceiling has burned out, but there is no obvious way to remove the bowl to get at the bulb.
Normally a flush mount fixture has a bolt than you can remove that will loosen the bowl, but not this one. There are no bolts, screws, or anything else. I have tried pushing up on the bowl and trying to turn it. No luck. I am completely clueless.


I’ve seen some that were “spring-loaded”, basically you just pulled them down and the spring extended. Only then could you change your bulb. Hope I’ve helped you out. . . . . best of luck to you.
Grab the metal part of the fixture that is flush with the ceiling and gently pull down. It will slide down on 2 springlike wires.
.
The trim ring will pull straight down.
the trim ring will remove by pulling downward
Put a screw driver under the edge and twist side wise, it’s a spring loaded set. It will snap down with force. It goes back with force also, watch out for the fingers.